Quality product but expensive!

 Cheap products but only for a few days?

 Not to mention the cases where you bought a product that was both expensive and “fake”.

 A lot of risks can happen, if you do not identify a reputable supplier.

 This is not your fault at all. It’s our fault that we couldn’t find you! So if you have seen this post, do not hesitate to learn together through the BSK pneumatic diaphragm pump that we exclusively distribute to Vietnam.

1. Diaphragm Pump Introduction

• Unlike other diaphragm pumps on the market, BSK was born with the purpose of overcoming the errors that other diaphragm pumps on the market are making.
• At BSK will help you experience the feeling of operating the pump with optimal efficiency without losing too much energy from the air compressor.
• Thanks to the diaphragm construction closer to the air cap, there is less room for excess air.
• So, in the long run will help you save a considerable amount of operating costs.

For those of you who don’t know, a pneumatic diaphragm pump is a pump with two (or four) diaphragm attached and used with an air compressor to fuel the pump. So you will not have to be afraid of fire or explosion in operation. To know more about what is a pneumatic diaphragm pump, please come to the structure.

2. Diaphragm pump structure

Pump body: divided into 2 parts

• Fluid side: in direct contact with the liquid to be pumped. Including membrane, ball, ball base.
• Airside: in contact with compressed air, including the air divider, the air distribution valve, the air distribution unit, the valve that divides the air on both sides of the pump chamber, the O-ring sealing, the Gasket.

Air valve: the task of dispersing compressed air to the sides of the air pump chamber to push the pump to work

• Air is compressed, entering the chamber creating a pressure that pushes the diaphragm to the right and out, and the liquid is transferred.
• The right diaphragm pushes to the left, creating pressure so that the liquid is sucked into the chamber to prepare for the next pumping process of the left diaphragm.

Ball and seat:

• Balls are placed on a round base.
• During the suction process, the ball moves up and down creating a gap between them and the fluid passing through.
• In the ejection process, the ball stays close to the sealing base and does not allow the liquid to slide back. From there, create a one-way valve for the diaphragm pump.

Muffler: It is a part to help reduce noise when the compressed air pump is in operation. Parts are sold with the machine, which can be easily removed, installed and replaced.